Monday, September 01, 2008


Milling Stuff

In which Tommelise 2.0 goes operational in a mode not anticipated by the narrator...

Since the slave I2C chips haven't arrived, I decided to see if I could get Tommelise 2.0 runing as a 2.5D CNC milling machine since in that mode an extruder controller board isn't required. I began by milling blanks of poplar.

In this mode, I was able to debug the T2 positioning robot without using my 1/2-inch plastic sheet...
read more

Comments: Post a Comment

Links to this post:

Create a Link

<< Home

This page is powered by Blogger. Isn't yours?

Subscribe to
Posts [Atom]